How to Tighten Spark Plugs

Use the Champion torque recommendation below as a guide for tightening all spark plugs.

Step-by-Step Instructions

Tapered Seat Plugs

Step One

Install the new plug finger tight, and complete the installation with a torque wrench.

Note: If using a torque wrench vs. plug wrench, please refer to the Torque Recommendations chart below.

Step Two

Turn Finger Tight. A tapered seat plug does not use gaskets and requires one-sixteenth (1/16) turn.

Note: If using a torque wrench, please refer to the Torque Recommendations chart below.

Gasket Type Plugs

Step One

Turn Finger Tight. A new or reinstalled plug with a new gasket will require ⅜-⅝ turn to effect a gas tight seal depending on head material.

Note: If using a torque wrench, please refer to the Torque Recommendations chart below.

Step Two

For reinstalled plugs with a used gasket only a ¼ turn is required for gas tight seal for both cast iron and aluminum cylinder heads.

Note: If using a torque wrench, please refer to the Torque Recommendations chart below.

Torque Recommendations

*Torque recommendations are for new gaskets.

The content contained in this article is for entertainment and informational purposes only and should not be used in lieu of seeking professional advice from a certified technician or mechanic. We encourage you to consult with a certified technician or mechanic if you have specific questions or concerns relating to any of the topics covered herein. Under no circumstances will we be liable for any loss or damage caused by your reliance on any content.